AUTOMATIC PINNING MACHINE

AUTOMATIC PINNING MACHINE

1,Item No.: DL-2FB3                        
2,Power: Single phase AC220V/50HZ                        
3,Input power:880W                        
4,Currency: 4A                        
5,no-load speed: 30KRPM                        
6,tool shant diameter:3.175mm                        
7,Positioning hole diameter less than pin 0.06mm~0.07mm                        
8,PIN specification: Diameter: 3.0mm~3.2mm   Length: 12~18mm                        
9,input air tube: ø5*8 tubes   6KG*CM²                        
10 dust suction tube：ø1.5"                        
11,max process board size:660mm                        
12,min process board size:150mm                        
13,Machine size:1160*500*1230mm                        

Note:                                    
"1，plug in electric power, and pneumatic supply, place the pin into pin holder plate,
then turn on the power. In one time, every plate should hold not more than 1000pcs pins
2,when running, no one but worker was forbidden to step close
3, keep alertness. Hands must not keep close to pressure foot and punching tool
4,when operating, hands keep away from worktable and equipment
5,when positioning the pin on the board, place the board into positioning fixture, 
keep the board parallel with edge,then adjust the hand wheel,access to positioning  
fixture,after then ensure the board permenent, press the switch to open."